A 1-dodecanethiol-based phase transfer protocol for the highly efficient extraction of noble metal ions from aqueous phase

A 1-dodecanethiol-based phase-transfer protocol is developed for the extraction of noble metal ions from aqueous solution to a hydrocarbon phase, which calls for first mixing the aqueous metal ion solution with an ethanolic solution of 1-dodecanethiol, and then extracting the coordination compounds formed between noble metal ions and 1-dodecanethiol into a non-polar organic solvent. A number of characterization techniques, including inductively coupled plasma atomic emission spectroscopy, Fourier transform infrared spectroscopy, and thermogravimetric analysis demonstrate that this protocol could be applied to extract a wide variety of noble metal ions from water to dichloromethane with an efficiency of >96%, and has high selectivity for the separation of the noble metal ions from other transition metals. It is therefore an attractive alternative for the extraction of noble metals from water, soil, or waste printed circuit boards.     

自动电位滴定法测定烟气氨法脱硫模拟浆液中氯离子的研究

氯离子含量是氨法脱硫工艺中的一个重要监控指标,用自动电位滴定法测定氨法脱硫浆液中的氯离子。结果表明,实验加入乙醇有利于增大电位突跃幅度;pH值为3~5时实验结果准确;加标回收率为90%~110%;与莫尔法相比,测定结果准确度、精密度更高,且不受灰分颜色干扰;与离子色谱法测定结果准确度、精密度相近,但测定高浓度氯离子电位滴定法更有优势。     

典型可燃物燃烧烟尘物化特性差异性研究

开展对典型可燃物燃烧烟尘的物化特性差异性研究,是全面了解烟尘信息的基础.基于可控条件下的燃烧试验,对典型可燃物燃烧烟尘物理特性和化学组分进行了分析.通过对比分析汽油燃烧烟尘、聚苯乙烯燃烧烟尘、ABS燃烧烟尘及柴油烟尘和正庚烷烟尘的透射电镜图片,对透射电镜图的紧凑性、复杂性及灰度值进行了深入分析,探讨了燃烧烟尘的物理差异性.利用固相微萃取-气质联用技术(SPME-GC-MS),对汽油燃烧烟尘、聚苯乙烯燃烧烟尘、ABS燃烧烟尘化学组分进行了分析和对比.通过燃烧烟尘的特征物质组分的分析,得到3种燃烧烟尘在特征物质的分布和出峰时间等方面的差异性.这些差异性可作为对烟尘来源及燃烧条件等因素判别的依据.     

丙二酸二(2-(2,3-二羟基苯甲酰胺)乙基)酯的合成与螯合性能研究

用2,3-二羟基苯甲酸经羟基保护、酰胺化、酯化和去保护4步反应,生成一种新型的四齿丙二酸二(2-(2,3-二羟基苯甲酰胺)乙基)酯配体.采用傅里叶变换红外光谱(FT-IR)、紫外-可见光谱(UV-Vis)、核磁共振氢谱(1H NMR)、核磁共振碳谱(13C NMR)和质谱(MS)对其结构进行了表征.在中性pH值条件下,研究了这种配体对铀酰离子的络合能力.结果表明,丙二酸二(2-(2,3-二羟基苯甲酰胺)乙基)酯配体与铀酰离子的螯合常数为23.2.     

液化四氟乙烷小孔泄漏试验研究

采用高速摄影技术,考察了液化四氟乙烷发生小孔泄漏时,其水平泄漏和垂直泄漏的初始云团演化行为、泄漏的质量流率、喷射速度和喷射角,并与理论计算公式进行了对比。结果表明:水平喷射两相云团尾部出现涡流,涡流大幅加快了云团向空气中扩散的速率;垂直喷射的两相云团在地面形成液池,液池大幅增加了液化气体向空气中蒸发的速率。水平泄漏试验的喷射角与容器内超压变化规律相似,泄放初期喷射角逐渐增大,经历一段平坦期,到泄放末期喷射角减小。水平泄漏和垂直泄漏的初始喷射速度分别为25 m/s和20 m/s,与理论值26.6 m/s基本吻合。水平泄漏的质量流率的试验值和理论值分别为0.0598 kg/s和0.0684 kg/s,垂直泄漏的分别为0.0472 kg/s和0.059 6 kg/s,结果对比基本吻合,推荐的泄漏质量流率和小孔喷射速度公式可以用于液化四氟乙烷小孔泄漏。     

液氮泡沫发生器内流动特性研究

低温液氮与泡沫混合液直接接触产生氮气泡沫是一种新型的掺混形式,利用液氮高汽化比的特点,搭建液氮泡沫可视化实验装置,进行氮气-水两相流及液氮泡沫流动特性的研究。结果表明,液氮相变产生大量氮气,其与泡沫液混合产生泡沫,温度有所回升,最终趋于泡沫混合液温度;管路沿程压降较小;液氮射流破碎及流动过程可分为6个区域:低温液氮区、向上循环翻滚区、滞留区、泡沫与泡沫混合液混合区、致密泡沫区、泡沫混合液区。流体向下游流动过程中持续发泡;为防止管路结冰,需合理控制泡沫混合液与液氮流量。     

基于RFPA2D复合局部挠曲岩体数值模拟

为研究复合局部挠曲岩体强度特征以及破坏规律，采用岩石真实破裂软件RFPA^2D，对水平层面挠曲30°，45°，60°，75°的复合岩体进行单轴压缩试验模拟。模拟结果表明:挠曲角为30°，45°，60°，75°的复合岩体破坏面几乎与挠曲段夹层重合，其挠曲端部均产生了垂直于挠曲段夹层的裂纹；复合单斜岩体与复合挠曲岩体破坏面的形成因素大致相同，夹层强度是2种岩体失稳的主要因素；复合挠曲岩体单轴抗压强度随挠曲角增大同样呈“U”型变化，与单斜岩体变化趋势一致；当水平层状岩体发生挠曲后，其单轴抗压强度减小，当挠曲角为60°时，强度降低25.19%，当挠曲角为75°时，强度降低0.17%。；随着均质系数m的增大，复合挠曲岩体单轴抗压强度以及轴向应变均出现逐渐递增的趋势，且不同m值，其岩体裂隙扩展方式具有明显差别。     

高效液相色谱-三重四级杆/复合线性离子阱质谱法测定饮用水中22种邻苯二甲酸酯

建立了一种同时测定饮用水中22种邻苯二甲酸酯(PAEs)的高效液相色谱-三重四级杆/复合线性离子阱质谱方法:饮用水样品经针头过滤器过滤,选用Biphenyl液相色谱柱进行分离,以含0.1%甲酸的水溶液和含0.1%甲酸的甲醇溶液为流动相,电离模式为电喷雾正离子,选用多反应监测触发增强子离子扫描模式进行检测。结果表明,22种PAEs的灵敏度良好,定量限为0.001～0.1 μg/L。配制浓度为0.1～100.0 μg/L的混标溶液进行进样分析,分析结果显示,22种PAEs在该范围内的线性关系良好,相关系数均大于0.995,方法的平均回收率为82.9%～108.9%,相对标准偏差为0.9%～11.2%。同时,使用增强子离子扫描谱图进行搜库匹配,定性准确性高。该方法适用于饮用水中PAEs的检测。     

碱熔融—微波晶化法合成粉煤灰沸石及其对Cd2+的吸附

以粉煤灰为主要原料，采用碱熔融—微波晶化法合成粉煤灰沸石。采用XRD，SEM，TEM等技术表征了粉煤灰沸石的微观结构，并对其吸附Cd²⁺的性能进行了研究。表征结果显示，粉煤灰沸石主要由X型沸石、P型沸石和铝组成，粉煤灰沸石中有排列规则、呈蜂窝状的孔穴和孔道存在，其孔穴和孔道大小分布均匀，致密。粉煤灰沸石的比表面积为108.49 m²/g，平均孔径为3.779 nm，孔体积为0.221 mL/g。实验结果表明，在溶液pH为7、吸附时间30 min的最佳吸附条件下，Cd²⁺去除率均大于94%。粉煤灰沸石对Cd²⁺的吸附可很好地用二级动力学方程进行拟合，相关系数为0.999 99。可用Langmuir等温吸附模型描述该吸附过程，该吸附过程是单分子层吸附，主要是化学吸附，粉煤灰沸石对Cd²⁺的饱和吸附量为49.261 mg/g。     

Risk Assessment of 26 Polycyclic Aromatic Hydrocarbon (PAH) Compounds in Parkıng Garages

The aim of this study was to determine the level of 26 polycyclic aromatic hydrocarbons (PAHs) at parking garages and to provide the necessary annual information based on occupational inhalation exposure and non-occupational inhalation exposure, which carry risks for the environment. For this purpose, 22 samples were collected continuously from both gas and particulates phase PAHs from two parking garages at Konya City Center, Turkey. The exposure-based risk of these samples was evaluated using concentrations of the carcinogenic PAH compounds. None of the 26 PAHs measured had values exceeding the recommended exposure limits (RELs) standard values for inhalation rate recommended by the World Health Organization (WHO). Exposure levels of gas and particulate PAHs for the occupational group and the public (children and adults who spend time in shopping centers) were found to be 0.07–28.24 μgm^?3 and 0.05–5.753 μgm^?3, respectively, representing levels two to four times higher than those at the control site. Maximum daily inhalation of B[a]Py was estimated at 1.33 ngd^?1 for exposure of the public and as 274 ngd^?1 for the occupational group. It is believed that traffic makes a substantial contribution to the PAH profile, which had relatively high concentrations of naphthalene (Napth) and coronene (Coro). Highly carcinogenic dibenzo(a,l)pyrene (B[al]Pyre) was found in the ambient air at two parking garages. Napth and phenanthrene (Phen) were the main compounds found in nearly all the tested samples. In this study, benzo[e]pyrene (B[e]Py) was used as a reference for PAHs because its concentration is stable and does not change seasonally. Considering the importance of these compounds in relation to human health, the aim of this work was to characterize and quantify the more toxic PAHs in parking garages. Conducting PAH sampling and their chemical analysis is very costly and labor intensive. This study produced data that can be a powerful tool for environmental forensics.